Журналы →  Tsvetnye Metally →  2014 →  №12 →  Назад

STRUCTURE OF METALS AND ALLOYS
Название Development of crystallographic texture in the time of rolling or Zr monocrystals and their recrystallization
Автор Isaenkova M. G., Perlovich Yu. A., Soe San Thu, Krymskaya O. A., Fesenko V. A.
Информация об авторе

National Research Nuclear University MEPhI (Moscow Engineering Physics Institute), Moscow, Russia:

M. G. Isaenkova, Professor, e-mail: isamarg@mail.ru
Yu. A. Perlovich, Leading Researcher
Soe San Thu, Post-Graduate Student
O. A. Krymskaya, Assistant
V. A. Fesenko, Senior Researcher

Реферат

This paper shows the research of peculiarities of the processes of Zr monocrystals reorientation during their rolling and following recrystallization. Use of monocrystals with different orientation relatively to outer directions of rolled plate allows to observe the reorientation of basal normals in the case of twinning and/or slip activization. The obtained results confirm and define the previously observed regularities of texture formation in pure Zr and its alloys, consisting of three stages of rolling texture development and consecutive activization of deformation mechanisms. The diagram of predominant plastic deformation mechanisms, calculated for α-Zr rolling, is not valid for all crystal orientations. Compression can activate twinning within regions of basal and prismatic slip operation. Under the monocrystal rolling, the twinning is capable to provide the formation of components, dominating in α-Zr texture at all further stages of texture development. However, at the same time, this twinning is accompanied by the slip, responsible for the level of strain hardening, sufficient for recrystallization. There were revealed the regularities of new grains growth during the subsequent recrystallization, entirely determinated by deformation mechanisms, operated at rolling stage. Regions of α-Zr matrix, deformed with predominant participation of twinning, are characterized by a decreased tendency to recrystallization. During the recrystallization in α-Zr there is implemented the mechanism of predominant growth of regions with maximum deformation hardening, corresponding by their orientation to the slopes of rolling texture maximal.

Ключевые слова Zirconium, monocrystal, rolling, crystallographic texture, plastic deformation mechanisms, slip, twinning, recrystallization, strain hardening
Библиографический список

1. Tenckhoff E. Deformation mechanisms, texture and anisotropy in Zirconium and Zircaloy. Philadelphia : ASTM, 1988. 77 p.
2. Tenckhoff Е. The development of the deformation texture in zirconium during rolling in sequential passes. Metallurgical Transaction A. 1978. No. 9. pp. 1401–1412.
3. Kocks U. F., Tome C. N., Wenk H.-R. Texture and Anisotropy : preferred orientations in polycrystals and their effect on materials properties. Cambridge : Cambridge University Press, 1998. 676 p.
4. Isaenkova M. G. Zakonomernosti razvitiya kristallograficheskoy tekstury i substrukturnoy neodnorodnosti v tsirkonievykh splavakh pri deformatsionnom i termicheskom vozdeystviyakh : Dissertatisya … doktora fiziko-matematicheskikh nauk (Regularities of development of crystallographic texture and substructure inhomogeneity in zirconium alloys with deformation and thermal influence: Dissertation of … Doctor of Physical and Mathematical Sciences). Moscow, 2011. 47 p.
5. Akhtar A. Prismatic slip in Zr monocrystals at elevated temperatures. Metallurgical Transaction A. 1975. No. 6. pp. 1217–1222.
6. Akhtar A. Basal slip in Zirconium. Acta Metallurgica. 1973. Vol. 21, No. 1. pp. 1–11.
7. Hobson D. O. Textures in deformed zirconium monocrystals. Transactions of the Metallurgical Society of AIME. 1968. Vol. 242. pp. 1105–1110.
8. Matsegorin I. V., Rusakov A. A., Evstyukhin A. I. Analiz mekhanizma teksturoobrazovaniya v α-tsirkonii s primeneniem modelirovaniya na elektronno-vychislitelnoy mashine (Analysis of mechanism of texture formation in α-zirconium with application of computer modeling). V sbornike: Metallurgiya i metallovedenie chistykh metallov (In the collection: metallurgy and metal science of pure metals). Moscow : Atomizdat, 1980. Iss. 14. pp. 39–52.
9. Phillippe M. J., Serghat M., Van Houtte P., Esling C. Modeling of texture evolution for materials of hexagonal symmetry. II. Application to zirconium and titanium  or near  alloys. Acta Metallurgica et Materialia. 1993. Vol. 43. pp. 1619–1630.

Language of full-text русский
Полный текст статьи Получить
Назад